+#endstop_debounce_count 100 # uncomment if you get noise on your endstops, default is 100
+
+# optional Z probe
+zprobe.enable false # set to true to enable a zprobe
+zprobe.probe_pin 1.29!^ # pin probe is attached to if NC remove the !
+zprobe.slow_feedrate 5 # mm/sec probe feed rate
+#zprobe.debounce_count 100 # set if noisy
+zprobe.fast_feedrate 100 # move feedrate mm/sec
+zprobe.probe_height 5 # how much above bed to start probe
+
+# associated with zprobe the leveling strategy to use
+#leveling-strategy.three-point-leveling.enable true # a leveling strategy that probes three points to define a plane and keeps the Z parallel to that plane
+#leveling-strategy.three-point-leveling.point1 100.0,0.0 # the first probe point (x,y) optional may be defined with M557
+#leveling-strategy.three-point-leveling.point2 200.0,200.0 # the second probe point (x,y)
+#leveling-strategy.three-point-leveling.point3 0.0,200.0 # the third probe point (x,y)
+#leveling-strategy.three-point-leveling.home_first true # home the XY axis before probing
+#leveling-strategy.three-point-leveling.tolerance 0.03 # the probe tolerance in mm, anything less that this will be ignored, default is 0.03mm
+
+