Reprap Wilson Assembly Guide
Written by Martin Rice <mrice411@gmail.com>
-* For the latest version of this document, check the "docs" folder at *
-* https://github.com/mjrice/wilson *
-* Please refer to the wilson-bom spreedsheet for a comprehensive list of *
-* parts needed before you begin. *
++ For the latest version of this document, check the "docs" folder at +
++ https://github.com/mjrice/wilson +
++ +
++ Please refer to the wilson-bom spreedsheet for a comprehensive list of +
++ parts needed before you begin. +
++ +
++ You will find photos of most of the steps below indexed by the step +
++ number, located in the images/ folder. +
1. Assemble the Y axis (part 1)
two nuts on each extrusion and attach the braces with a total of 8 M5
screws. Note that the longer extrusions (the "sides" of the frame)
should cover the ends of the bottom extrusion piece. Leave the screws
- loose until all 8 are started. Stand the frame "upright" to ensure the
- sides are slid down flush with the bottom and alternately tighten until
- all the screws are tight.
+ loose until all 8 are started.
+* Stand the frame "upright" to ensure the sides are slid down flush with
+ the bottom and alternately tighten until all the screws are tight.
* Rotate the frame so the other side is facing you and put it back flat
on your work surface.
* Slide two more T nuts into each side piece and attach the motor mounts