Reprap Wilson Assembly Guide
Written by Martin Rice <mrice411@gmail.com>
+* For the latest version of this document, check the "docs" folder at *
+* https://github.com/mjrice/wilson *
+* Please refer to the wilson-bom spreedsheet for a comprehensive list of *
+* parts needed before you begin. *
+
1. Assemble the Y axis (part 1)
1.1 Gather the following parts
d. The four linear bearing holders
e. Eight miniature zip ties
-
* Place the heat bed circuitboard over the wood bed and mark the four
corner locations with a pencil.
* Put the heat bed circuitboard aside and place the four linear bearing
* You will need:
a. Filament holder mounts
b. SMART display mounts
- c. M5 x 8mm screws
+ c. RAMPS electronics frame mount
+ c. Eight M5 x 8mm screws
7.6 Attach heat bed
* You will need:
a. The heat bed circuitboard
- b. Four M3 x 25mm screws and locknuts
+ b. Four M3 x 30mm screws and locknuts
c. Four springs (approx 1" long uncompressed)
* This is a good time to attach the heat bed thermistor if you have not
b. The power supply
c. SMART display (optional)
+* Use the checklist below as you connect the electronics. If your
+ electronics board has multiple options for connecting devices, make a
+ note of which connection you use so that you can input the settings
+ to your firmware.
+
+ [ ] X axis stepper motor
+ [ ] Y axis stepper motor
+ [ ] Z axis stepper motors (2)
+ [ ] Extruder stepper motor
+ [ ] X axis limit switch
+ [ ] Y axis limit switch
+ [ ] Z axis limit switch
+ [ ] Heat bed power
+ [ ] Extruder heater power
+ [ ] Extruder fan power
+
+
+
+
+
+
+
+
+
+