put back rear frame bracket for RS, the TS version interfers with RS beam bracket

[clinton/wilson.git] / doc / how-to-build.txt

diff --git a/doc/how-to-build.txt b/doc/how-to-build.txt
index 5433141..77a0c20 100644 (file)
--- a/doc/how-to-build.txt
+++ b/doc/how-to-build.txt
@@ -161,7 +161,10 @@ Set the prepared wood print bed aside.
        a.      The two plastic X end pieces ("motor" and "idler") 
        b.      Eight linear bearings (LM8UU) 
        c.      The two X axis smooth rods 
-       d.      Two M5 nuts     
+       d.      Two M5 nuts
+       e.      X endstop limit switch
+       f.      One M3 x 30mm screw and nut
+       g.      One spring      
 
 4.2 Hardware Assembly
 
@@ -169,6 +172,11 @@ Set the prepared wood print bed aside.
 *      Using pliers, gently press an M5 nut into the provided insert in each 
        end. 
 *      Place two linear bearings on each of the smooth rods. 
+*   Insert the X endstop switch (previously wired) into the slot provided
+       on the X motor end.  Route the wires down and through the guide on
+       the bottom side of the end.  Secure with a zip tie.
+*      Press an M3 nut into the bottom of the Z axis adjuster, then thread 
+       an M3 x 30mm screw through a spring and into the nut from the top side.
 *      Press each X end onto the pair of smooth rods, being sure to orient 
        them so that the M5 nuts are on the same side of the rods.