2 OPT_DEFS
+= -DMITOSIS_PROMICRO
3 MITOSIS_UPLOAD_COMMAND
= while
[ ! -r
$(USB
) ]; do sleep
1; done
; \
4 avrdude
-p
$(MCU
) -c avr109
-U flash
:w
:$(TARGET
).hex
-P
$(USB
)
6 # # project specific files
14 # Processor frequency.
15 # This will define a symbol, F_CPU, in all source code files equal to the
16 # processor frequency in Hz. You can then use this symbol in your source code to
17 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
18 # automatically to create a 32-bit value in your source code.
20 # This will be an integer division of F_USB below, as it is sourced by
21 # F_USB after it has run through any CPU prescalers. Note that this value
22 # does not *change* the processor frequency - it should merely be updated to
23 # reflect the processor speed set externally so that the code can use accurate
30 # Target architecture (see library "Board Types" documentation).
33 # Input clock frequency.
34 # This will define a symbol, F_USB, in all source code files equal to the
35 # input clock frequency (before any prescaling is performed) in Hz. This value may
36 # differ from F_CPU if prescaling is used on the latter, and is required as the
37 # raw input clock is fed directly to the PLL sections of the AVR for high speed
38 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
39 # at the end, this will be done automatically to create a 32-bit value in your
42 # If no clock division is performed on the input clock inside the AVR (via the
43 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
47 # This definition is optional, and if your keyboard supports multiple bootloaders of
48 # different sizes, comment this out, and the correct address will be loaded
49 # automatically (+60). See bootloader.mk for all options.
52 # Interrupt driven control endpoint task(+60)
53 OPT_DEFS
+= -DINTERRUPT_CONTROL_ENDPOINT
56 # comment out to disable the options.
58 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
59 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
60 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
61 CONSOLE_ENABLE
= yes
# Console for debug(+400)
62 COMMAND_ENABLE
= yes
# Commands for debug and configuration
63 CUSTOM_MATRIX
= yes
# Remote matrix from the wireless bridge
64 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
65 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
66 NKRO_ENABLE
= yes
# USB Nkey Rollover - not yet supported in LUFA
67 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
68 # MIDI_ENABLE = yes # MIDI controls
69 UNICODE_ENABLE
= yes
# Unicode
70 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
75 # $(MITOSIS_UPLOAD_COMMAND)