6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
20 # Target architecture (see library "Board Types" documentation).
24 # Input clock frequency.
25 # This will define a symbol, F_USB, in all source code files equal to the
26 # input clock frequency (before any prescaling is performed) in Hz. This value may
27 # differ from F_CPU if prescaling is used on the latter, and is required as the
28 # raw input clock is fed directly to the PLL sections of the AVR for high speed
29 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
30 # at the end, this will be done automatically to create a 32-bit value in your
33 # If no clock division is performed on the input clock inside the AVR (via the
34 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
38 # Interrupt driven control endpoint task(+60)
39 OPT_DEFS
+= -DINTERRUPT_CONTROL_ENDPOINT
42 # Boot Section Size in *bytes*
44 # Teensy++ halfKay 1024
45 # Atmel DFU loader 4096
46 # LUFA bootloader 4096
48 BOOTLOADER
= atmel-dfu
52 BOOTMAGIC_ENABLE
= yes
# Virtual DIP switch configuration(+1000)
53 MOUSEKEY_ENABLE
= yes
# Mouse keys(+4700)
54 EXTRAKEY_ENABLE
= yes
# Audio control and System control(+450)
55 CONSOLE_ENABLE
= no
# Console for debug(+400)
56 COMMAND_ENABLE
= no
# Commands for debug and configuration
57 NKRO_ENABLE
= yes
# Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
58 BACKLIGHT_ENABLE
= yes
# Enable keyboard backlight functionality
59 MIDI_ENABLE
= no
# MIDI controls
60 AUDIO_ENABLE
= no
# Audio output on port C6
61 UNICODE_ENABLE
= no
# Unicode
62 BLUETOOTH_ENABLE
= no
# Enable Bluetooth with the Adafruit EZ-Key HID
63 RGBLIGHT_ENABLE
= yes
# Enable WS2812 RGB underlight.
64 SLEEP_LED_ENABLE
= no
# Breathing sleep LED during USB suspend