keyboards/bigseries/rules.mk

   1 #SRC += rgb_backlight.c
   2
   3 # MCU name
   4 MCU = atmega32u2
   5
   6 # Processor frequency.
   7 #     This will define a symbol, F_CPU, in all source code files equal to the
   8 #     processor frequency in Hz. You can then use this symbol in your source code to
   9 #     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
  10 #     automatically to create a 32-bit value in your source code.
  11 #
  12 #     This will be an integer division of F_USB below, as it is sourced by
  13 #     F_USB after it has run through any CPU prescalers. Note that this value
  14 #     does not *change* the processor frequency - it should merely be updated to
  15 #     reflect the processor speed set externally so that the code can use accurate
  16 #     software delays.
  17 F_CPU = 16000000
  18
  19 #
  20 # LUFA specific
  21 #
  22 # Target architecture (see library "Board Types" documentation).
  23 ARCH = AVR8
  24
  25 # Input clock frequency.
  26 #     This will define a symbol, F_USB, in all source code files equal to the
  27 #     input clock frequency (before any prescaling is performed) in Hz. This value may
  28 #     differ from F_CPU if prescaling is used on the latter, and is required as the
  29 #     raw input clock is fed directly to the PLL sections of the AVR for high speed
  30 #     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
  31 #     at the end, this will be done automatically to create a 32-bit value in your
  32 #     source code.
  33 #
  34 #     If no clock division is performed on the input clock inside the AVR (via the
  35 #     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
  36 F_USB = $(F_CPU)
  37
  38 # Interrupt driven control endpoint task(+60)
  39 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
  40
  41
  42 # Boot Section Size in *bytes*
  43 OPT_DEFS += -DBOOTLOADER_SIZE=4096
  44
  45
  46 # Build Options
  47 #   comment out to disable the options.
  48 #
  49 BOOTMAGIC_ENABLE  = no  # Virtual DIP switch configuration(+1000)
  50 MOUSEKEY_ENABLE  = no   # Mouse keys(+4700)
  51 EXTRAKEY_ENABLE  = yes  # Audio control and System control(+450)
  52 CONSOLE_ENABLE  = yes   # Console for debug(+400)
  53 COMMAND_ENABLE  = yes    # Commands for debug and configuration
  54 SLEEP_LED_ENABLE  = no  # Breathing sleep LED during USB suspend
  55 NKRO_ENABLE  = no               # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
  56 BACKLIGHT_ENABLE  = no  # Custom backlighting code is used, so this should not be enabled
  57 AUDIO_ENABLE  = no # This can be enabled if a speaker is connected to the expansion port. Not compatible with RGBLIGHT below
  58 RGBLIGHT_ENABLE  = yes # This can be enabled if a ws2812 strip is connected to the expansion port.
  59