[Docs] Clarify Zadig usage in FAQ Docs (#6360)
[jackhill/qmk/firmware.git] / docs / fuse.txt
1 Atmega32u4 Fuse/Lock Bits for Planck/Atomic/Preonic
2 =========================
3
4 Low Fuse: 0x5E
5 High Fuse: 0x99
6 Extended Fuse: 0xF3
7 Lock Byte: 0xFF
8
9
10 ATMega168P Fuse/Lock Bits
11 =========================
12 This configuration is from usbasploader's Makefile.
13
14 HFUSE 0xD6
15 LFUSE 0xDF
16 EFUSE 0x00
17 LOCK 0x3F(intact)
18
19 #---------------------------------------------------------------------
20 # ATMega168P
21 #---------------------------------------------------------------------
22 # Fuse extended byte:
23 # 0x00 = 0 0 0 0 0 0 0 0 <-- BOOTRST (boot reset vector at 0x1800)
24 # \+/
25 # +------- BOOTSZ (00 = 2k bytes)
26 # Fuse high byte:
27 # 0xd6 = 1 1 0 1 0 1 1 0
28 # ^ ^ ^ ^ ^ \-+-/
29 # | | | | | +------ BODLEVEL 0..2 (110 = 1.8 V)
30 # | | | | + --------- EESAVE (preserve EEPROM over chip erase)
31 # | | | +-------------- WDTON (if 0: watchdog always on)
32 # | | +---------------- SPIEN (allow serial programming)
33 # | +------------------ DWEN (debug wire enable)
34 # +-------------------- RSTDISBL (reset pin is enabled)
35 # Fuse low byte:
36 # 0xdf = 1 1 0 1 1 1 1 1
37 # ^ ^ \ / \--+--/
38 # | | | +------- CKSEL 3..0 (external >8M crystal)
39 # | | +--------------- SUT 1..0 (crystal osc, BOD enabled)
40 # | +------------------ CKOUT (if 0: Clock output enabled)
41 # +-------------------- CKDIV8 (if 0: divide by 8)
42
43
44 # Lock Bits
45 # 0x3f = - - 1 1 1 1 1 1
46 # \ / \-/ \-/
47 # | | +----- LB 2..1 (No memory lock features enabled)
48 # | +--------- BLB0 2..1 (No restrictions for SPM or LPM accessing the Application section)
49 # +--------------- BLB1 2..1 (No restrictions for SPM or LPM accessing the Boot Loader section)
50