HCoop / clinton / wilson.git / blame
| Commit | Line | Data |
|---|---|---|
| 6bdc8b4e MR |
1 | -------------------------------------------- |
| 2 | How to Assemble the Reprap Wilson 3D printer | |
| 3 | Written by Martin Rice <mrice411@gmail.com> | |
| 4 | -------------------------------------------- | |
| 5 | ||
| 6 | 1. Identify the components | |
| 7 | ||
| 8 | 2. Assemble the Y axis (part 1) | |
| 9 | ||
| fe3c2048 | 10 | 2.1 The following parts are used during this step: |
| 6bdc8b4e MR |
11 | a. The two M10 threaded rods |
| 12 | b. The Y axis smooth rods | |
| 13 | c. The plastic Y end pieces (2) | |
| 14 | d. The two plastic frame brace supports | |
| 15 | e. 12 M10 nuts and washers | |
| 16 | f. Four linear bearings (LM8UU) | |
| 17 | ||
| 18 | 3. Assemble the Frame (part 1) | |
| 19 | ||
| fe3c2048 | 20 | 3.1 The following parts are used during this step: |
| 6bdc8b4e MR |
21 | a. The two side pieces of 2020 aluminum extrusion (the longer ones, generally) |
| 22 | b. One of the two horizontal pieces of 2020 aluminum extrusion (the shorter ones, generally) | |
| 23 | c. 36 T-slot nuts | |
| 24 | d. 28 M5 x 8mm screws | |
| 25 | e. The plastic Z motor holders (2) | |
| 26 | f. The plastic rear frame brackets (2) | |
| 27 | ||
| 28 | 4. Mount the Y axis to the frame | |
| 29 | ||
| fe3c2048 MR |
30 | 4.1 The following parts are used during this step: |
| 31 | a. The partially-assembled Y axis from step 2. | |
| 32 | b. The partially assembled frame from step 3. | |
| 33 | c. Eight M5 x 8mm screws | |
| 34 | ||
| 35 | ||
| 6bdc8b4e MR |
36 | 5. Assemble the X axis (part 1) |
| 37 | ||
| fe3c2048 MR |
38 | 5.1 The following parts are used during this step: |
| 39 | a. The two plastic X end pieces ("motor" and "idler") | |
| 40 | b. Eight linear bearings (LM8UU) | |
| 41 | c. The two X axis smooth rods | |
| 42 | ||
| 6bdc8b4e MR |
43 | 6. Mounting the X axis to the Z axis |
| 44 | ||
| 45 | 7. Assemble the Frame (part 2) | |
| 46 | ||
| 47 | ||
| 48 |