//#define CONTROLLER_IS_XWHATSIT_MODEL_F_OR_WCASS_MODEL_F
#define CONTROLLER_IS_XWHATSIT_BEAMSPRING_REV_4
-//#define CONTROLLER_IS_THROUGHT_HOLE_BEAMSPRING
+//#define CONTROLLER_IS_THROUGH_HOLE_BEAMSPRING
+//#define CONTROLLER_IS_THROUGH_HOLE_MODEL_F
#define CAPSENSE_KEYBOARD_SETTLE_TIME_US 8
#define CAPSENSE_DAC_SETTLE_TIME_US 8
//#define SOLENOID_DEFAULT_DWELL 12
//#define SOLENOID_MIN_DWELL 4
//#define SOLENOID_MAX_DWELL 100
+
+// If the lock lights are not used, then please don't define the below pins,
+// or leave them set as unused pins:
+
+// The following definitions match the lock lights as used by the original
+// xwhatsit firmware, but enabling all three of these is not compatible with
+// standard solenoid support, because B6 and B7 pins are already in use:
+//#define LED_NUM_LOCK_PIN B5
+//#define LED_CAPS_LOCK_PIN B6
+//#define LED_SCROLL_LOCK_PIN B4
+// Since solenoid support is enabled by default, the above lock light pin
+// assignments are disabled by default.
+// Instead the more common Num Lock and Caps Lock are assigned the following
+// way by default, and this can be used in combination with the solenoid:
+#define LED_NUM_LOCK_PIN B4
+#define LED_CAPS_LOCK_PIN B5
+
+// Uncomment below if the leds are on when the pin is driving zero:
+//#define LED_NUM_LOCK_ACTIVE_LOW
+//#define LED_CAPS_LOCK_ACTIVE_LOW
+//#define LED_SCROLL_LOCK_ACTIVE_LOW
+
+#include "../../../post_config.h"