note issues with current rev in code

may be a while before issues are resolved, they are not particularly
major.

diff --git a/scad/x-end.scad b/scad/x-end.scad
index 4cb9fa8..1a47ab0 100644 (file)
--- a/scad/x-end.scad
+++ b/scad/x-end.scad
@@ -10,6 +10,17 @@
 
 // bearing height, strain relief (&& maybe make dependent upon the bearing diameter)
 
+
+
+// major issues with rev 3
+
+// - motor side screw hole conflicts with switch / other rear mount is
+//   inaccessible without removing the leadscrew from the nut
+
+// - New idler anti-pitching ribs are too big (new idler I wasn't
+//   using is larger so the existing ones worked fine for that one...)
+//   NOTE: new idler is meant for integrated toothed idler...
+
 use <bearing.scad>
 include <configuration.scad>