Exported bom for Wilson TS from wilson-bom.ods 
Please see the ODS file for details.  
----------------------------------------------

Item                                    Quantity	Length / Notes

2020 Extrusions		
Vertical frame piece (sides)            2           400mm
Horizontal frame piece (top and bottom) 2           320mm
Y axis frame piece (TS only)            2           415mm

M8 Smooth Rods		
X-Axis                                  2           380mm
Y-Axis                                  2           415mm
Z-Axis                                  2           350mm

Threaded Rods		
M5 threaded rod for Z axis              2           325mm

Belts & Pulleys		
Y axis GT2 timing belt (w=6mm)          1           850mm
X axis GT2 timing belt (w=6mm)          1           930mm
GT2 pulley                              2           Want diameter 16-20mm
Nuts & Bolts		
M5 x 10mm machine screw                 44	
M5 hex nut                               2	
M5 t slot nut                           44	
M4 x 20mm machine screw                  6	
M4 hex nut                               6	
M3 x 8mm machine screw                   1	
M3 x 10mm machine screw                 11	
M3 x 14mm machine screw                 18	
M3 x 30mm machine screw                  7	
M3 x 60mm machine screw                  2         50mm? if spring short enough
M3 hex nut                             20?         This number is approximate
M3 lock nut                              7	
M3 washer                              20?         This number is approximate
M8 x 20mm smooth rod or grub screw       1	
M8 washers                               5         For alignment of hobbed bolt
M8 locknut                               1         For extruder bolt
Printed Parts – Required		
X end idler                              1	
X end motor                              1	
X carriage                               1	
Y end idler                              1	
Y end motor                              1	
Y belt holder                            1	
Y axis bearing holder                    4         for lm8uu bearings
Z motor holder, left                     1	
Z motor holder, right                    1	
Z rod holder, left                       1	
Z rod holder, right                      1	
Z rear bracket                           2	
Z endstop holder                         1	
Frame brace                              4	
Idler bearing guide (pair)               2	
Extruder body / idler set                1	
Extruder big gear / small gear set       1	
Extruder fan duct                        1	
Belt guides	                             4         (two belt guides, one for each 624 bearing)
Printed Parts – Recommended		
Electronics frame mount (for RAMPS)	1	
Filament spool support (two pieces)	1	
SMART display frame mount (two pieces)	1	
Everything Else		
NEMA17 Stepper motor	5	
MDF board (6mm thick)	1	230mm by 230mm
MK2 Heat bed	1	
Glass bed	1	3mm borosilicate
Controller (Mega/RAMPS, Rambo, etc)	1	
Endstop (limit) switch	3	6mm x 10mm x 20mm
LM8UU Linear bearing	12	
608ZZ roller bearing	4	
624 roller bearing	2	
5mm to 5mm shaft couplers	2	Can also use vinyl tubing instead
40mm x 40mm x 10mm fan	1	12V
80mm x 80mm fan	1	For use with RAMPS frame mount
Miniature zip ties	20	This number is approximate
Extruder idler springs	2	High tension 
Bed leveling springs	4	Lower tension
Power Supply	1	Size appropriately for heat bed and extruder
Hobbed bolt	1	Recommend airwolf3d
Hot end	1	Recommend Jhead