# Allow Exim to recognize addresses of the form "user@[10.11.12.13]",
# where the domain part is a "domain literal" (an IP address) instead
# of a named domain. The RFCs require this facility, but it is disabled
-# in the default config since it is seldomly used and frequently abused.
+# in the default config since it is rarely used and frequently abused.
# Domain literal support also needs a special router, which is automatically
# enabled if you use the enable macro MAIN_ALLOW_DOMAIN_LITERALS.
# Additionally, you might want to make your local IP addresses (or @[])
primary_hostname = MAIN_HARDCODE_PRIMARY_HOSTNAME
.endif
-# The settings below, which are actually the same as the defaults in the
-# code, cause Exim to make RFC 1413 (ident) callbacks for all incoming SMTP
-# calls. You can limit the hosts to which these calls are made, and/or change
-# the timeout that is used. If you set the timeout to zero, all RFC 1413 calls
-# are disabled. RFC 1413 calls are cheap and can provide useful information
-# for tracing problem messages, but some hosts and firewalls are
-# misconfigured to drop the requests instead of either answering or
-# rejecting them. This can result in a timeout instead of an immediate refused
-# connection, leading to delays on starting up SMTP sessions. (The default was
-# reduced from 30s to 5s for release 4.61.)
-# rfc1413_hosts = *
-# rfc1413_query_timeout = 5s
+# The settings below cause Exim to make RFC 1413 (ident) callbacks
+# for all incoming SMTP calls. You can limit the hosts to which these
+# calls are made, and/or change the timeout that is used. If you set
+# the timeout to zero, all RFC 1413 calls are disabled. RFC 1413 calls
+# are cheap and can provide useful information for tracing problem
+# messages, but some hosts and firewalls have problems with them.
+# This can result in a timeout instead of an immediate refused
+# connection, leading to delays on starting up SMTP sessions.
+# (The default was reduced from 30s to 5s for release 4.61. and to
+# disabled for release 4.86)
+#
+#rfc1413_hosts = *
+#rfc1413_query_timeout = 5s
+
+
+# Enable an efficiency feature. We advertise the feature; clients
+# may request to use it. For multi-recipient mails we then can
+# reject or accept per-user after the message is received.
+#
+prdr_enable = true
# When using an external relay tester (such as rt.njabl.org and/or the
# currently defunct relay-test.mail-abuse.org, the test may be aborted