Updated Sample Configs

[clinton/Smoothieware.git] / ConfigSamples / FirePick.delta / config

diff --git a/ConfigSamples/FirePick.delta/config b/ConfigSamples/FirePick.delta/config
index a7c0197..4af39a9 100644 (file)
--- a/ConfigSamples/FirePick.delta/config
+++ b/ConfigSamples/FirePick.delta/config
@@ -131,11 +131,13 @@ delta_current                                   1.5              # First extrude
 # Laser module configuration
 laser_module_enable                          false            # Whether to activate the laser module at all. All configuration is
                                                               # ignored if false.
-#laser_module_pin                             2.5             # this pin will be PWMed to control the laser. Only P2.0 - P2.5
+#laser_module_pin                             2.5             # this pin will be PWMed to control the laser. Only P2.0 - P2.5, P1.18, P1.20, P1.21, P1.23, P1.24, P1.26, P3.25, P3.26
                                                               # can be used since laser requires hardware PWM
-#laser_module_max_power                       0.8             # this is the maximum duty cycle that will be applied to the laser
-#laser_module_tickle_power                    0.0             # this duty cycle will be used for travel moves to keep the laser
-                                                              # active without actually burning
+#laser_module_maximum_power                   1.0             # this is the maximum duty cycle that will be applied to the laser
+#laser_module_minimum_power                   0.0             # This is a value just below the minimum duty cycle that keeps the laser
+                                                              # active without actually burning.
+#laser_module_default_power                   0.8             # This is the default laser power that will be used for cuts if a power has not been specified.  The value is a scale between
+                                                              # the maximum and minimum power levels specified above
 #laser_module_pwm_period                      20              # this sets the pwm frequency as the period in microseconds
 
 # Hotend temperature control configuration
@@ -323,4 +325,3 @@ network.ip_address                           auto             # use dhcp to get
 #network.ip_mask                              255.255.255.0    # the ip mask
 #network.ip_gateway                           192.168.3.1      # the gateway address
 #network.mac_override                         xx.xx.xx.xx.xx.xx  # override the mac address, only do this if you have a conflict
-